Rotate the blade to bring the marked tooth to 1/2 inch above the table at the rear of the blade.Adjust the combination square to that the ruler tip touches the marked blade tooth and lock the ruler. Place the base of a combination square in the right side miter gauge groove.Rotate the marked blade tooth so that it's 1/2 inch above the table at the front of the blade. Mark the right side of one blade tooth using a felt-tip marker. Loosen the bevel lock, set the blade to 90-degrees (straight up), and then tighten the bevel lock handle.Raise the blade to its highest cutting position and lift off the blade guard assembly.Unplug the table saw’s power cord from the wall outlet.How to adjust the blade alignment on your Delta table saw
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |